Page 1 of 1

HedgeHog position shows X: 0 Y: 0 Z: 0

Posted: Fri Oct 25, 2019 9:47 pm
by puneeth

I am using the Starter Set Hw v4.9 for my hobby project and had a quick question. I have a Raspberry PI connected via USB to the mobile beacon and am using the Python library mentioned in the downloads page to access the position of the mobile beacon. The 4 stationary beacons are all setup. I consistently get the following message: "Hedge 0: X: 0 m, Y: 0 m, Z: 0 m, Angle: 0 at time T: 0.00". There is a constant clicking sound observed as well from the mobile beacon.

Any clues how to solve this?