Page 1 of 1

Position of the hedgehog on each submap not showing, despite pressing the "M2" Button

Posted: Fri Mar 12, 2021 3:09 pm
by tommclean
I have set up two sub maps near eachother in a small room:

Image

If I turn off the stationary beacons in submap 1, the position is shown on submap 0. If I then turn off the beacons on submap 0 and turn on the ones on submap 1, the position is shown on submap 1. When I turn both submaps on and press the "M2" button, it only ever shows the position in one of the submaps. For instance, if I now add a service zone to submap 1, the position is shown on submap 0 instead

Image

How can I make the position on each submap show at the same time, so I can align the submaps?

Thanks.

Re: Position of the hedgehog on each submap not showing, despite pressing the "M2" Button

Posted: Wed Apr 14, 2021 7:43 pm
by smoker77
Hello,

Do you use IA or NIA system?
What is the vertical line from beacon 2 on the screenshot - is this a service zone of some submap?
If it is a service zone of submap0 (zone with only two points), mobile beacon can't be located inside.
Are both submaps and the map frozen?
We will check the issue on our side, but please clarify these questions.